Skip to content
International Academy of Science, Technology, Engineering and Management (IASTEM)

Conference Proceedings

IASTEM INTERNATIONAL CONFERENCE, Oslo, Norway 03-12-2018

← All proceedings

Proceedings cover: IASTEM INTERNATIONAL CONFERENCE, Oslo, Norway 03-12-2018

IASTEM INTERNATIONAL CONFERENCE

Oslo, Norway 03-12-2018

2 papers

  1. Analysis of Fabricated Al Metal Matrix Composites Reinforced With Ti-62222 Via Multi Pass Friction Stir Processing

    Adedotun Adetunla, Esther Akinlabi

    Paper ID IA-ICMAEOSLO-03128-9524 · Pages 1-6

    Abstract

    This paper investigates the fabrication of Aluminum Matrix Composite (AMC) and Ti-62222 powder by multi pass Friction Stir Processing (FSP). Grooves were machined on the Aluminum sheets to deposit the titanium powder, which is the reinforcement and the sheets were processed at some sets of parameters. Scanning Electron Microscopy (SEM) and an optical system were used to observe the microstructures. To determine the wear behavior, pin-on-disc apparatus was used to analyze the wear resistance of the samples. The results indicate that the number of passes greatly affect the particle distribution of the reinforcement as expected, which subsequently influenced the composite characteristics such as the wear resistance and hardness profiles. A homogenous distribution of the Ti-62222 particles in the Al matrix was observed at the third pass from the SEM and EDX analyses and a significant enhancement in the Vickers micro hardness was observed. Lastly, the grain sizes of the processed samples were characterized, the finest grains measured were found to be an average size of 1.6μm, which is 97.5% smaller when compared to the parent metal at 65.23μm, these grain sizes are produced by the sample fabricated after three passes. The sets of processing parameters considered and the number of passes can be considered for typical surface engineering applications. Index Terms— Ti-62222, multi pass friction stir processing, composite materials, mechanical properties, microstructure.

    Download PDF: Analysis of Fabricated Al Metal Matrix Composites Reinforced With Ti-62222 Via Multi Pass Friction Stir Processing
  2. Effect of Reinforcement on Mechanical Properties of Al Alloy

    Adedotun Adetunla, Esther Akinlabi

    Paper ID IA-ICMAEOSLO-03128-9713 · Pages 7-12

    Abstract

    In the present research, multi-pass friction stir processing (FSP) was employed on both reinforced and un-reinforced 1100 Al alloy. The reinforcement powder used was a Ti-6Al-4V powder. The number of passes was limited to four due to the unfavourable results observed for excessive number of passes above four. After four(4) cumulative FSP passes, the microstructures of the samples were observed with Optical microscopic while the tensile tests were done at room temperature via an Instron electronic tensile machine. The result reveals that the microstructure of the first two passes of the reinforced Al alloy shows clustering of Ti-6Al-4V particles and uneven distribution of the particles, which in turn affects the strength of the samples. Also at 2passes, the ultimate tensile stress of the reinforced 1100 Al alloy was 20% lesser than the unreinforced sample, while at 3 passes for both samples, a noticeable 30% increment was seen for the reinforced Al alloy when compared with the unreinforced sample. The result shows that to successfully reinforce Al alloy, to achieve a higher strength, better wear performance and even dispersion of particles, at least 3-passes should be employed. Index Terms— Microstructure, multi pass friction stir processing, Tensile property, wear

    Download PDF: Effect of Reinforcement on Mechanical Properties of Al Alloy