Skip to content
International Academy of Science, Technology, Engineering and Management (IASTEM)

Conference Proceedings

IASTEM INTERNATIONAL CONFERENCE, Miami, USA 30-12-2016

← All proceedings

Proceedings cover: IASTEM INTERNATIONAL CONFERENCE, Miami, USA 30-12-2016

IASTEM INTERNATIONAL CONFERENCE

Miami, USA 30-12-2016

3 papers

  1. Partial-Resonant Flyback Converter Analysis and Comparison to The Standard Flyback Converter

    A. Alforidi, D.M aslam

    Paper ID IA-ICRAETUSA-30126-2231 · Pages 1-6

    Abstract

    Pulse Width Modulation (PWM) is commonly used in power electronics applications thanks to its simplicity and effectiveness. However, it suffers from high switching losses, frequency limitation, and need for clamping circuits. Resonant and partial resonant converters are created to find solutions to these problems. Their main aim is to decrease the switching losses and enable higher frequency operation. A novel Partial-Resonant Flyback converter was presented in 2014 and its operation and advantages were explained in this referred paper. This paper aims to conduct a detailed loss analysis between this referred topology and PWMFlyback. Moreover, some practical issues such as semiconductor switch, inductor, output capacitor, and gating circuit selection were also compared between two topologies. A simulation model was used for this purpose and the results were presented. Keywords- pulse width modulation; partial resonant; Flyback converter; loss analysis; reverse blocking IGBT.

    Download PDF: Partial-Resonant Flyback Converter Analysis and Comparison to The Standard Flyback Converter
  2. D Latch Flip Flop Using Spatial Wave Function Switched Field-Effect Transistors

    B. Saman1, P. Gogna, E. Heller, F.c jain

    Paper ID IA-ICRAETUSA-30126-2540 · Pages 7-8

    Abstract

    This paper aims at designing D-Latch circuits that are 25% smaller in size by using high-mobility n-channel spatial wavefunction switching SWSFETs which provide significant reduction of cell area and power dissipation. SWS-FETs comprise of vertically stacked quantum well/quantum dot channels allowing the drain current flow in multiple channels in a single transistor1. A two quantum channel SWS-FET structure comprises of two Si quantum wells sandwiched between SiGe barriers (as shown in Fig. 1). The fabrication process of SWS-FETs is compatible with conventional complementary metal-oxide-semiconductor (CMOS) FETs2. This device allows the drain current flow in multiple channels in a single transistor (Fig. 2 shows the IDS-VGS characteristics of a two well single SWS-FET). D Latches find applications including shift register, one bit delay and memories. It has 4 NAND gates with each gate having 4 transistors “2 n-MOS and 2 p-MOS”. The two inputs signal the data and the clock control the output Q. When the clock “Ck” is high, the Q output follows any changes from data “D”, and when the clock “Ck” is low, the Q is latched and the Q output will not change states even when data changes. The SWS-NAND logic gates can be realized using three n-SWS-FET3 as shown in Fig. 3, and Fig 4 shows the simulation result. In this work four SWS-NAND gates are used to perform D Latch function, the Figure 5 presents the schematic circuit of the D Latch flip flop and the comparison between SWS and CMOS D Latch shows in figure 6, the conventional CMOS circuit has 16 transistors” 8-pmos and 8-nmos” , but the SWS has only 12-n channel SWS FET transistors. Where CMOS process parameters is 0.35μm and SWS model is based on integration between Berkeley Short-channel IGFET Model (BSIM) and Analog Behavioral Model.

    Download PDF: D Latch Flip Flop Using Spatial Wave Function Switched Field-Effect Transistors
  3. Can Creativity and Critical Thinking Be Taught

    James Livingston, Ruth Livingston

    Paper ID IA-ICSSHUSA-30126-2250 · Pages 9-11

    Abstract

    Throughout human history, creativity has solved problems through science, technology, art, and human communication. Researchers suggest that creativity is on the decline. Educators and professionals consider the question; are we born creative or can environments be designed to cultivate creativity? Studies suggest creativity is born from necessity, and it is cultivated through ideal learning environments. This paper posits that creativity is innate within humans, and learning environments can be developed for students to discover techniques and solutions within their fields of study. Keywords- Creativity, Learning Environments, Problem Solving, Invention

    Download PDF: Can Creativity and Critical Thinking Be Taught