50TH IASTEM INTERNATIONAL CONFERENCE
Dhaka, Bangladesh 01-04-2017
6 papers
-
Geotechnical Interpretation Of Soil For The Proposed Underground Utility Tunnel From Kuril To Malibagh In Dhaka City
Souptik Barman Tirtha, Johana Sharmin, Mst. Mariam akhtar
Paper ID IA-ICCAEDHKA-01047-3252 · Pages 1-5
Download PDF: Geotechnical Interpretation Of Soil For The Proposed Underground Utility Tunnel From Kuril To Malibagh In Dhaka CityAbstract
For the proposition of establishment of upcoming 7.7 km common utility tunnel under Progoti Sarani in Dhaka between Kuril flyover and Malibagh Chowdhurypara, Dhaka North City Corporation (DNCC) has stepped forward to complete a feasibility study report accumulating all soil test data around Dhaka city found from different secondary organizations. Besides that, four boreholes to a depth of about 30m each were drilled at different locations and consequent laboratory tests are also done as per the requirement. In that perspective, a new aspect of geological and geotechnical site of Dhaka city soil profile is prepared based on those primary and secondary data focusing a single part of city from Kuril to Malibagh. The prepared soil profile is compared with the geomorphological map of Dhaka city published by Geological Survey of Bangladesh (GSB) and found that most of the soil in Dhaka city is of Madhupur terrace (clayey silt and silty clay) of Pleistocene era. The range of liquid limit of maximum data in the project is between 40 and 60, plasticity index is greater than 4 and limit values between 'A' line [0.73(LL-20)] and 'U' line [0.9(LL-8)] of plasticity chart, so the soil criteria will be CL (Inorganic clays of low to medium plasticity, gravelly clays, sandy clays, silty clays, lean clays) and CH (Inorganic clays of high plasticity, fat clays). The soil is found Over Consolidated Clay (OCC) because in most of the cases natural water content (W) is close to Plastic limit (PL). Most of the clay minerals are found Illite and Kaolinite which is classified between Inactive and Normal clays (Activity ratio, A = 0.38 to 0.90) which means that there may be no significant swelling and shrinkage characteristics in the project area along with changing of water contents as well as the possibility of structural damage is also negligible. But a matter of concern is that in some points soils are collapsible according to plasticity index. Results of chemical analysis indicate that the sub-soils are not aggressive to concrete and not corrosive to reinforcement steel. Index Terms— Dhaka City, Geotechnical Interpretation, Subsurface Soil Profile, Soil Properties.
-
Energy For Sustainability
Aminul Islam, Bablu Kumar Ghosh
Paper ID IA-ICENSDHKA-01047-3178 · Pages 6-10
Download PDF: Energy For SustainabilityAbstract
In recent years, Bangladesh has suffered from sporadic shortages in electricity due to the rising energy demand faster than expected. Numerous policies have been reformed by the government over the past decades to balance country’s electricity demand and to create level playing field for both public and private sectors in order to bring reliable energy for more Bangladeshis in a smartest ways. Recently, the government has declared vision of electricity for all by 2021. Even though numbers of strategic initiatives have been put in place, the power sector vision has yet to be achieved. Thus, the power sector was perceived to be riddled with some fundamental weaknesses, which necessitated initiation of the reform process in the sector. This paper highlights a comprehensive overview of Bangladesh’s energy sector and identifies a set of challenges for policy makers attempting to influence the process of transforming the energy sector. Further concentrations were given on the basic understanding of overarching energy policy framework and features in energy sector. Finally, key energy challenges appearing across individual energy sectors were discussed and offered a strategic perspective into Bangladesh’s energy sector as a whole. Index Terms- Energy, Stratigetic Perspective
-
Environmental Challenge Cater Tandem Solar Cell Design On SI
Bablu K. Ghosh (Smieee), Aminul Islam, Ismail Saad, Khairul A. M
Paper ID IA-ICENSDHKA-01047-3188 · Pages 11-14
Download PDF: Environmental Challenge Cater Tandem Solar Cell Design On SIAbstract
The renewable energy as energy mix with conventional power sources can contributes a lots to minimize environment CO2. Solar cell, the most attractive and sustainable renewable source is capable to grip this issue if it could provide sufficient efficiency. Currently 1.1 eV Si (silicon) solar photovoltaic (SPV) efficiency limitation and scope of hetero-junction tandem cell have driven SPV research towards advanced environmental friendly solar cell. Aims to efficient carrier transport properties, Si based advanced cell design using potential absorbing materials (higher permittivity) /cell has been widely investigated. Nearly current matching series cells configuration with higher absorption edge top cell design on silicon is essential for this drive. Si cell ultimate efficiency improvement if the thermalisation and optical band reflection effect could be minimized. Carrier capturing before thermalisation by employing ≤1.8 eV cell and its effective photonic conversion by III-Ns (InGaN) may progress efficiency. The µ-Si and a-Si as Si nanostructure was realized to enhance wide band absorption. But direct and wide band gap III- nitride advancement of carrier dynamics has key carrier transport properties over Si nanostructure. Therefore, novel III-N materials SPV technologies towards efficiency progression have been studied. Index Terms- Environment compatible, green nanostructure, tandem, InGaN, Si, SPV
-
CFD Analysis Of Pressure Coefficient For Naca 4412 At Various Depths
MD. Ariful Hoque
Paper ID IA-ICMAEDHKA-01047-3275 · Pages 15-18
Download PDF: CFD Analysis Of Pressure Coefficient For Naca 4412 At Various DepthsAbstract
Pressure coefficient of a shallowly submerged cambered hydrofoil near free surface is simulated numerically in this research. The standard NACA 4412 hydrofoil section is used for thissimulation. A commercial computational fluid dynamics (CFD) code FLUENT based on finite volume technique is used for the analysis of the two-dimensional hydrofoil section. To get the pressure coefficient, ‘Volume of Fluid’ (VOF) method is incorporated in numerical simulation. Then pressure coefficients are computed for different submergence depth ratios, h/c ranging from 1 to 5. Variation of pressure coefficientsis plotted in the form of a dotted curve for Fn=1, and Re=3.11x 106in different h/c ratios. Keywords - Pressure Coefficients, Drag coefficient, Liftcoefficient, Hydrofoil, Computational domain.
-
Vibration Analysis Of The Rmhs (Raw Material Handling System) Booster Fan
MD. Ariful Hoque
Paper ID IA-ICMAEDHKA-01047-3311 · Pages 19-23
Download PDF: Vibration Analysis Of The Rmhs (Raw Material Handling System) Booster FanAbstract
Prevention is better than cure. Machine vibration is a useful indicator of machine condition. Vibration monitoring and analysis is a preventive tool that is applied to various bearings and gearboxes used in industries to understand the machine condition and take preventive action that helps avoid sudden breakdown, increase machine durability, and efficient machine performance. The objective of this study is to gather data using a specific tool and analyze the data. The analysis identifies the location of the defect and eliminates vibration sources which may cause detrimental effect to the machinery or the process. Keywords- Vibration, demodulation, condition monitoring, vibration analysis, spectrum
-
Design Optimization And Performance Evaluation Of Er Doped And Er-Yb Co-Doped Fiber Amplifier Considering Ion-Ion Interaction Effect
Md Sohel Mahmood, Mohammad Sakib Mahmood, Samia Jannat
Paper ID IA-ICRAETDHKA-01047-02 · Pages 24-25
Download PDF: Design Optimization And Performance Evaluation Of Er Doped And Er-Yb Co-Doped Fiber Amplifier Considering Ion-Ion Interaction EffectAbstract
Efficiency of fiber amplifier can be increased by doping with rare earth elements but ion-ion interaction effect limits the gain. This paper reviews the design and performance of Er and Er-Yb doped fiber amplifier. Keyword- Er-doping, Er-Yb co-doping, ion-ion interaction effect, upconversion effect.